|
|
|
RSVP(7) -- Resource ReSerVation Protocol general information
|
|
Resource ReSerVation Protocol, also known as RSVP, is an Internet protocol that enables Internet applications to request enhanced quality-of-service (QoS). The Internet application uses the RSVP Appli... |
|
rz(7) -- SCSI disk interface
|
|
The rz driver is for all HP Small Computer System Interface (SCSI) disk drives. There is one major number used to represent SCSI disks, pointing to the driver. The minor number (for scsi) is the SCSI ... |
|
|
sad(7) -- STREAMS Administrative Driver
|
|
The sad driver provides an interface to the autopush facility using the ioctl() function. As an interface, the sad driver enables administrative tasks to be performed on STREAMS modules and drivers. S... |
|
scc(7) -- Serial keyboard/mouse/communications interface
|
|
Two base board Zilog scc dual UARTS provide DEC 3000 series personal systems with keyboard, mouse, and serial communications interfaces. The serial communications interfaces can operate at baud rates ... |
|
SCSI(7) -- Small Computer System Interface
|
|
The operating system interfaces to disk and tape devices through the Small Computer System Interface (SCSI). SCSI support is limited to the HP-supplied storage devices and certain third-party devices.... |
|
slip_manual_setup(7) -- Describes how to manually set up the Serial Line Internet Protocol (SLIP)
|
|
The Serial Line Internet Protocol (SLIP) is a protocol used to run IP over serial lines, including RS-232 cables connecting two systems and telephone circuits. Unlike Ethernet, a serial line provides ... |
|
streamio(7) -- STREAMS ioctl commands
|
|
The STREAMS ioctl commands perform control operations on Streams. User processes can use these commands on all STREAMS file types. When the Stream head receives a STREAMS ioctl function, it interprets... |
|
strlog(7) -- STREAMS log driver
|
|
The STREAMS log driver allows user-level processes, and STREAMS drivers and modules, to perform error logging and event tracing. This is done via a user interface and a kernel interface. The interface... |
|
sys_attrs_vba_univ(7) -- Describes how
|
|
VMEbus UNIVERSE II setup allows you to run the operating system on UNIVERSE II-based Alpha VME systems. For information about installing the operating system on these systems, see the Installation Gui... |
|
sys_attrs_vba_vipvic(7) -- Describes how to
|
|
VMEbus setup allows you to run the operating system on the following VIP/VIC-based AXPvme and Alpha VME systems: AXPvme single-board computers (SBCs) Alpha VME 4/224 and 4/228 SBCs Alpha VME 5/352 and... |
|
sys_attrs_vme_vba(7) -- VMEbus backplane Ethernet interface
|
|
The VMEbus backplane (vb) interface provides access to an Ethernet network through the VMEbus backplane driver, which acts as an Ethernet Datalink Layer driver. This interface allows VMEbus-based syst... |
|
tablet(7) -- Configuring a CalComp graphics tablet
|
|
This reference page provides information about how you configure a CalComp DrawingBoard III tablet, an input device supported by the Xinput extension to the Xserver. When the software for the tablet i... |
|
tape(7) -- SCSI magnetic tape interface
|
|
The Small Computer System Interface (SCSI) tape driver provides a standard tape drive interface as described in mtio(7). This is the tape driver for any HP SCSI tape device. Facilities are provided wh... |
|
tcp(7) -- Internet Transmission Control Protocol (TCP)
|
|
The TCP protocol provides reliable, flow-controlled, twoway transmission of data. It is a byte-stream protocol used to support the SOCK_STREAM abstraction. The TCP protocol uses the standard Internet ... |
|
te(7) -- TGEC Ethernet interface
|
|
The te interface provides access to a 10 Mb/s Ethernet network through the TGEC controller. The host's Internet address is specified at boot time with an SIOCSIFADDR ioctl. The te interface employs t... |
