|
|
poll(7) -- Device driver for a fast poll on many file descriptors
|
|
The /dev/poll driver supports the monitoring of one or more sets of file descriptors. Access to the /dev/poll driver is supported through the open(), write(), and ioctl() functions. By using open(), w... |
|
ports(7) -- Device (tty and lp) names for serial and parallel ports
|
|
AlphaStation and AlphaServer systems provide one or two 9-pin serial communication ports. These ports are usually labelled 1 (COMM1) and 2 (COMM2), but they may be identified by different icons. Using... |
|
port_names(7) -- Device (tty and lp) names for serial and parallel ports
|
|
AlphaStation and AlphaServer systems provide one or two 9-pin serial communication ports. These ports are usually labelled 1 (COMM1) and 2 (COMM2), but they may be identified by different icons. Using... |
|
ppp_manual_setup(7) -- Describes how to manually set up Pointto-Point Protocol (PPP) connections
|
|
The Point-to-Point Protocol (PPP) provides a standard way to transmit IP datagrams over a serial link and a standard way for the systems (peers) at either end of the link to negotiate various optional... |
|
presto(7) -- The Prestoserve pseudodevice driver
|
|
The Prestoserve pseudodevice driver presto caches synchronous writes in nonvolatile memory. Prestoserve causes synchronous writes to be performed at memory speeds, rather than at disk speeds. Synchron... |
|
ptem(7) -- Null STREAMS module for pseudoterminal emulation
|
|
The ptem module is a null STREAMS module that Tru64 UNIX provides to applications for use in place of the AT&T System V Release 4 ptem module. The AT&T System V Release 4 ptem module emulates a pseudo... |
|
pty(7) -- Pseudo terminal driver
|
|
The pty driver provides support for a device-pair termed a pseudo terminal. A pseudo terminal is a pair of character devices, a master device and a slave device. The slave device provides an interface... |
|
ra(7) -- MSCP disk interface
|
|
This is a driver for all MSCP disk controllers. All controllers communicate with the host through a packet-oriented protocol termed the Mass Storage Control Protocol (MSCP). The following rules are us... |
|
RAID(7) -- Small Computer System Interface
|
|
The operating system interfaces to disk and tape devices through the Small Computer System Interface (SCSI). SCSI support is limited to the HP-supplied storage devices and certain third-party devices.... |
|
re(7) -- SWXCR RAID interface
|
|
The re driver is for the SWXCR RAID Array controller. The following rules are used to determine the major and minor numbers that are associated with an re type disk. There are two major numbers used t... |
|
ri(7) -- I2O RAID disk interface
|
|
The ri driver supports 32-bit and 64-bit PCI backplane RAID controllers with Intelligent I/O (I2O) host interface supporting backend SCSI channels. I2O is an open architecture for developing device dr... |
|
route(7) -- Kernel packet forwarding database
|
|
The UNIX operating system provides packet routing facilities. The kernel maintains a routing information database, which is used in selecting the appropriate network interface when transmitting packet... |
|
rsvp(7) -- Resource ReSerVation Protocol general information
|
|
Resource ReSerVation Protocol, also known as RSVP, is an Internet protocol that enables Internet applications to request enhanced quality-of-service (QoS). The Internet application uses the RSVP Appli... |
