sane-sm3600 - SANE backend for Microtek scanners M011 USB chip
The sane-sm3600 library implements a SANE (Scanner Access Now Easy)
backend that provides access to some Microtek scanners with the Toshiba
M011 custom USB chip. This backend should be considered alpha.
There exist a backends for Microtek scanners with SCSI command set.
Refer to sane-microtek(5) and sane-microtek2(5) for details.
At present, the following scanners are known positively to work with
this backend:
Vendor Product id: Remark:
-------- -------------- -----------
Microtek ScanMaker 3600 all modes ok
If you own a Microtek scanner with the M011 chip other than the ones
listed above, it may or may not work with SANE!
This backend dynamically enables the options for the frontend, that are
supported by the scanner in dependence of the scanning-mode and other
options. Not supported options are disabled.
The following options are supported by the Microtek2-driver:
Color, grayscale, halftone and lineart scans.
contrast, brightness, control, gamma correction.
This backend does not support device names in a usable form.
This backend does not support a configuration file right now.
/usr/lib/sane/libsane-sm3600.a
The static library implementing this backend.
/usr/lib/sane/libsane-sm3600.so
The shared library implementing this backend (present on systems
that support dynamic loading).
SANE_DEBUG_SM3600
If the library was compiled with debug support enabled, this
environment variable controls the debug level for this backend.
E.g., a value of 128 requests all debug output to be printed.
Smaller levels reduce verbosity. To see error messages on stderr
set SANE_DEBUG_SM3600 to 1.
E.g. just say:
export SANE_DEBUG_SM3600=5
sane(7), sane-microtek2(5)
Marian Eichholz ([email protected])
Glenn Ramsey ([email protected])
15.05.2001 sane-sm3600(5)
[ Back ] | 