|
|
if_sl(4) -- slip network interface
|
|
The sl interface allows serial lines to be used as network interfaces using the slip protocol. The sl interface can use Van Jacobson TCP header compression and ICMP filtering. This is arranged by usin... |
|
if_sn(4) -- Ethernet driver for SMC91Cxx based cards
|
|
The sn device driver supports SMC9xxx based ISA and PCMCIA cards. |
|
if_ste(4) -- Sundance Technologies ST201 fast ethernet device driver
|
|
The ste driver provides support for PCI ethernet adapters and embedded controllers based on the Sundance Technologies ST201 PCI fast ethernet controller chip. This includes the D-Link DFE-550TX. The S... |
|
if_stf(4) -- 6to4 tunnel interface
|
|
The stf interface supports ``6to4'' IPv6 in IPv4 encapsulation. It can tunnel IPv6 traffic over IPv4, as specified in RFC3056. For ordinary nodes in 6to4 site, you do not need stf interface. The stf... |
|
if_tap(4) -- Ethernet tunnel software network interface
|
|
The tap interface is a software loopback mechanism that can be loosely described as the network interface analog of the pty(4), that is, tap does for network interfaces what the pty driver does for te... |
|
if_ti(4) -- Alteon Networks Tigon I and Tigon II gigabit ethernet driver
|
|
The ti driver provides support for PCI gigabit ethernet adapters based on the Alteon Networks Tigon gigabit ethernet controller chip. The Tigon contains an embedded R4000 CPU, gigabit MAC, dual DMA ch... |
|
if_tl(4) -- Texas Instruments ThunderLAN ethernet device driver
|
|
The tl driver provides support for PCI ethernet adapters based on the Texas Instruments ThunderLAN ethernet controller chip. This includes a large number of Compaq PCI-bus ethernet adapters as well as... |
|
if_tun(4) -- tunnel software network interface
|
|
The tun interface is a software loopback mechanism that can be loosely described as the network interface analog of the pty(4), that is, tun does for network interfaces what the pty(4) driver does for... |
|
if_txp(4) -- 3Com 3XP Typhoon/Sidewinder (3CR990) Ethernet interface
|
|
The txp interface provides access to the 10Mb/s and 100Mb/s Ethernet networks via the 3Com Typhoon/Sidewinder chipset. This driver supports the following cards: +o 3Com 3CR990-TX-95 +o 3Com 3CR990-TX-... |
|
if_vlan(4) -- IEEE 802.1Q VLAN network interface
|
|
The vlan driver demultiplexes frames tagged according to the IEEE 802.1Q standard into logical vlan network interfaces, which allows routing/bridging between multiple VLANs through a single switch tru... |
|
if_vr(4) -- VIA Technologies Rhine I/II/III ethernet device driver
|
|
The vr driver provides support for PCI ethernet adapters and embedded controllers based on the VIA Technologies VT3043 Rhine I, VT86C100A Rhine II, and VT6105/VT6105M Rhine III fast ethernet controlle... |
|
if_wb(4) -- Winbond W89C840F fast ethernet device driver
|
|
The wb driver provides support for PCI ethernet adapters and embedded controllers based on the Winbond W89C840F fast ethernet controller chip. This includes the Trendware TE100-PCIE and various other ... |
|
if_wi(4) -- Lucent Hermes, Intersil PRISM and Spectrum24 IEEE 802.11 driver
|
|
The wi driver provides support for wireless network adapters based around the Lucent Hermes, Intersil PRISM-II, Intersil PRISM-2.5, Intersil Prism-3, and Symbol Spectrum24 chipsets. All five chipsets ... |
