NAME    [Toc]    [Back]

     quotacheck -- file system quota consistency checker

SYNOPSIS    [Toc]    [Back]

     quotacheck [-g] [-u] [-v] filesystem file ...
     quotacheck [-g] [-u] [-v] -a

DESCRIPTION    [Toc]    [Back]

     The quotacheck utility examines each file system, builds a table of current
 disk usage, and compares this table against that recorded in the
     disk quota file for the file system.  If any inconsistencies are
     detected, both the quota file and the current system copy of the incorrect
 quotas are updated (the latter only occurs if an active file system
     is checked).  By default both user and group quotas are checked.

     The following options are available:

     -a      If supplied in place of any file system names, quotacheck will
	     check all the file systems indicated in /etc/fstab to be readwrite
 with disk quotas.  By default only the types of quotas
	     listed in /etc/fstab are checked.

     -g      Only group quotas listed in /etc/fstab are to be checked.

     -u      Only user quotas listed in /etc/fstab are to be checked.

     -v      Report discrepancies between the calculated and recorded disk
	     quotas and other additional diagnostic messages.

     Specifying both -g and -u is equivalent to the default.  Parallel passes
     are run on the file systems required, using the pass numbers in
     /etc/fstab in an identical fashion to fsck(8).

     Normally, quotacheck operates silently.

     The quotacheck utility expects each file system to be checked to have a
     quota files named quota.user and quota.group which are located at the
     root of the associated file system.  These defaults may be overridden in
     /etc/fstab.  If a file is not present, quotacheck will create it.	These
     files should be edited with the edquota(8) utility.

     The quotacheck utility is normally run at boot time from the /etc/rc
     file.  The rc startup procedure is controlled by the /etc/rc.conf variable
 check_quotas.  Note that to enable this functionality in /etc/rc you
     also need to enable startup quota procedures with the variable
     enable_quotas in /etc/rc.conf.

     The quotacheck utility accesses the raw device in calculating the actual
     disk usage for each user.	Thus, the file systems checked should be quiescent
 while quotacheck is running.

FILES    [Toc]    [Back]

     quota.user   at the file system root with user quotas
     quota.group  at the file system root with group quotas
     /etc/fstab   default file systems

SEE ALSO    [Toc]    [Back]

     quota(1), quotactl(2), fstab(5), edquota(8), fsck(8), quotaon(8),
     repquota(8)

HISTORY    [Toc]    [Back]

     The quotacheck utility appeared in 4.2BSD.


FreeBSD 5.2.1			 June 5, 1993			 FreeBSD 5.2.1