nos-tun -- implement ``nos'' or ``ka9q'' style IP over IP tunnel
nos-tun -t tunnel -s source -d destination -p protocol_number target
The nos-tun utility is used to establish an nos style tunnel, (also known
as ka9q or IP-IP tunnel) using a tun(4) kernel interface.
Tunnel is the name of the tunnel device /dev/tun0 for example.
Source and destination are the addresses used on the tunnel device. If
you configure the tunnel against a cisco router, use a netmask of
``255.255.255.252'' on the cisco. This is because the tunnel is a pointto-point
interface in the FreeBSD end, a concept cisco doesn't really
implement.
Protocol number sets tunnel mode. Original KA9Q NOS uses 94 but many
people use 4 on the worldwide backbone of ampr.org.
Target is the address of the remote tunnel device, this must match the
source address set on the remote end.
This end, a FreeBSD box on address 192.168.59.34:
nos-tun -t /dev/tun0 -s 192.168.61.1 -d 192.168.61.2 192.168.56.45
Remote cisco on address 192.168.56.45:
interface tunnel 0
ip address 192.168.61.2 255.255.255.252
tunnel mode nos
tunnel destination 192.168.59.34
tunnel source 192.168.56.45
We don't allow for setting our source address for multihomed machines.
Nickolay N. Dudorov <[email protected]> wrote the program, Poul-Henning
Kamp <[email protected]> wrote the man-page. Isao SEKI <[email protected]>
added a new flag, IP protocol number.
FreeBSD 5.2.1 April 11, 1998 FreeBSD 5.2.1 [ Back ] | 