|
|
|
cua(4) -- general terminal interface
|
|
This section describes the interface to the terminal drivers in the system. Terminal Special Files [Toc] [Back] Each hardware terminal port on the system usually has a terminal special device fi... |
|
cue(4) -- CATC USB-EL1201A USB Ethernet driver
|
|
The cue driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation's USB-EL1202A chipset. This includes the following adapters: Belkin F5U111 CATC Netmate C... |
|
|
cy(4) -- Cyclades Cyclom-{4, 8, 16}Y asynchronous comms board device driver
|
|
This driver provides an interface to Cyclades Cyclom-4Y, Cyclom-8Y and Cyclom-16Y asynchronous multiport serial boards. These boards are based around Cirrus Logic CD1400 communication controllers. The... |
|
cz(4) -- Cyclades-Z series multi-port serial adapter device driver
|
|
The cz device driver supports the Cyclades-Z series of multi-port serial adapters. The Cyclades-Z is an intelligent serial controller comprising: +o PLX9060ES PCI bus interface +o Xilinx XC5204 FPGA +... |
|
sparc/daadio(4) -- MATRIX MD-DAADIO digital/analog, analog/digital, parallel i/o board
|
|
The daadio driver provides ioctl(2) entry points to read and write analog/digital, digital/analog, and parallel input/output registers. A typical daadio has 6 8bit parallel ports, 8 12bit DAC ports, a... |
|
dc(4) -- DEC/Intel 21140, 21142, 21143, 21145 and clones 10/100 Ethernet
|
|
The dc driver provides support for several PCI, MiniPCI, and CardBus Fast Ethernet adapters and embedded controllers based on the following chipsets: +o DEC 21140 PCI +o DEC/Intel 21143 PCI and CardBu... |
|
hp300/dca(4) -- HP 98644A serial communications interface
|
|
The 98644A is a single port EIA RS-232C (CCITT V.28) communications interface with a single character buffer. Such an interface is built-in to all series 300 machines. Input and output for each line m... |
|
hp300/dcm(4) -- HP 98642A serial communications multiplexer
|
|
The 98642A is a four port EIA RS-232C (CCITT V.28) communications multiplexer. The 98642A has three direct-connect ports and one port with full modem control. Input and output for each line may be set... |
|
dcphy(4) -- Pseudo-driver for media support on DEC 21143 controllers
|
|
The dcphy driver handles media selection on the DEC 21143 chip as it has no real MII interface. |
|
ddb(4) -- kernel debugger
|
|
The ddb debugger provides a means for debugging the kernel, and analysing the kernel after a system crash ("panic"), with a gdb(1)-like syntax. ddb is only available if the kernel was configured wit... |
|
vax/de(4) -- DEC DEUNA/DELUA 10 Mb/s Ethernet interface
|
|
The de interface provides access to a 10 Mb/s Ethernet network through a Digital Equipment UNIBUS Network Adapter (DEUNA). Each of the host's network addresses is specified at boot time with an SIOCS... |
|
de(4) -- DEC DC21x4x (Tulip) Ethernet driver
|
|
The de device driver supports Ethernet adapters based on the Digital Equipment DC21x4x based self-contained Ethernet chips. This includes, among others, the following models: Asante Cogent EM100FX and... |
|
vax/dhu(4) -- DHU-11/DHV-11 communications multiplexer
|
|
A DHU-11 provides 16 communication lines. Normal I/O control parameters for individual lines are managed by ioctl(2) calls. Individual DHU-11 lines may be configured to run at any of 13 speeds (50, 20... |
|
hppa/dino(4) -- Dino and Cujo Host/PCI bridges
|
|
This driver supports Dino and Cujo Host/PCI bridges found on the A, B, and C models of workstations. Cujo is a 64 bit datapath version of Dino. On some machines it may also provide an additional seria... |
|
hp300/dio(4) -- DIO/DIO-II bus
|
|
This driver is for the DIO/DIO-II bus on HP 9000/3xx and 9000/4xx series workstations. |
