The slattach utility is used to assign a tty line to a network interface, and to define the network source and destination addresses. The following options are available: -a Autoenable the VJ header c...
The slattach utility is used to assign a tty line to a network interface, and to define the network source and destination addresses. The following options are available: -a Autoenable the VJ header c...
The sliplogin utility is used to turn the terminal line on standard input (or device) into a Serial Line IP (SLIP) link to a remote host. To do this, the program searches the file /etc/sliphome/slip.h...
The slstat utility reports certain kernel statistics kept about serial line internet protocol traffic. The options are as follows: -i Repeat the display indefinitely every interval seconds. If no inte...
The smrsh program is intended as a replacement for sh for use in the ``prog'' mailer in sendmail(8) configuration files. It sharply limits the commands that can be run using the ``|program'' synta...
The sppp(4) driver might require a number of additional arguments or optional parameters besides the settings that can be adjusted with ifconfig(8). These are things like authentication protocol param...
The spray utility sends multiple RPC packets to host and records how many of them were correctly received and how long it took. The options are as follows: -c count Send count packets. -d delay Pause ...
ssh-keysign is used by ssh(1) to access the local host keys and generate the digital signature required during hostbased authentication with SSH protocol version 2. ssh-keysign is disabled by default ...
sshd (SSH Daemon) is the daemon program for ssh(1). Together these programs replace rlogin and rsh, and provide secure encrypted communications between two untrusted hosts over an insecure network. Th...
A special file mode, called the sticky bit (mode S_ISVTX), is used to indicate special treatment for directories. It is ignored for regular files. See chmod(2) or the file for an explanat...
The stlload utility is used to download the firmware code to Stallion Technologies intelligent multiport serial boards. A firmware download is only required for those boards that use the Stallion stli...
The stlstats utility is used to display statistical information about the ports on Stallion Technologies multiport serial boards. The stlstats utility normally runs as a full screen menu driven applic...
Strfile reads a file containing groups of lines separated by a line containing a single percent `%' sign and creates a data file which contains a header structure and a table of file offsets for each...
The swapon, swapoff and swapctl utilities are used to control swap devices in the system. At boot time all swap entries in /etc/fstab are added automatically when the system goes multi-user. Swap devi...
